Aastra ATP-CNX-040-01 Bedienungsanleitung PDF herunterladen (Seite 29)

Configure the network settings

ATP-CNX-040-01 Rel. 1.3, Doc. Rev. 01.07 1-11

Aastra CNX Installation and Setup Procedures

Configure the network settings

Requirements

The following is required before you configure the Aastra CNX for the first time:

• The Aastra CNX must physically be connected to your console using an

RS-232/DB-9 cable.

• The Aastra CNX must physically be connected to your network interface via

the Ethernet port(s).

• The Aastra CNX must be turned on.

• You must be running a terminal emulator on your PC. Terminal emulator must

be set as follows:

— Baud Rate 9600

—Data 8 bit

— Parity None

—Stop 1 bit

—Flow Control None

After powering up the Aastra CNX, a network script runs in a terminal emulator

window allowing you to initially configure the unit for your network.

Procedure

The following procedure describes how to configure the network settings.

Note: If at any time during the initial configuration process, you want to

backout of the configuration, press <ESC> to cancel.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 189 190

Keine Kommentare

Aastra ATP-CNX-040-01 Bedienungsanleitung Seite 29